It's been a busy month and you can see from the hours posting I've been busy assembling the left wing. I'm getting close to finishing this wing. I'd say 15 or 20 more hours. I have the wing tip and position light to install.
View of flaperon bracket installation prior to installing top wing panels.
Example of the wing skeleton, typical, prior to wing panel closure. I choose to primer only the contact surfaces of the interior wing. I did remember to remove the FOD.
Example of the priming method. This happens to be the lower mid-skin. You can see the access panel near the stall warning device.
Inboard wing-walk panel primed and ready to install.
Top panels are cleco'd in place and ready to rivet. Inboard wing section primed at location where wing walk panel is installed
Just a few Cleco's holding the panel in place.
With the exception of a few rivets I forgot to install, all panels are riveted in place. Must be 1200 closely placed rivets.
No comments:
Post a Comment